Chipping and flaking often ensues, when amateur painters attempt to paint aluminum shutters. Most typically do-it-yourself painters blame it on the paint. In reality, the offender is practically always improper surface preparation. You should pick the right paint, depending on the place of the aluminum shutters. Like you browse through aluminum shutters online before buying one, the same research needs to go into choosing a paint for these.
Choosing the Right Paint for Aliminium Shutters
Unless they’re pre-treated with a special sort of acidic primer, capable of etching metallic surfaces no type of paint will stick to aluminum shutters. Before you paint, coat the shutters with a galvanised metal etching primer. Once they are properly primed, they are going to take any kind of paint.
If you’re painting the interior part of your aluminum shutters in Sydney, you should choose a latex paint. Select a gloss latex paint if you need the shutters to stand out. Pick a satin latex paint if you had enjoy the shutters to blend in with the encircling wall.
Exterior aluminum shutters are exposed to temperatures and harsh climate conditions. These shutters require an acrylic latex paint, which will be capable of contracting and expanding in altering temperatures.
You might want to use acrylic enamel, if the shutters are exposed to moderate to high degree of duress. Acrylic enamels are considerably more permanent than normal acrylic latex paints and impart an appealing sheen.
Prepararing Aliminium Shutters for Painting
Remove the shutters from your house for simple access. Moreover, new paint won’t stick to old paint that is still shiny. Sanding the surface with 220-grit sandpaper works well on the level regions. The last step before painting is a methodical cleaning of the shutters with a non- a stiff nylon scrub brush and phosphate cleanser. Traditional construction cleaners, like trisodium phosphate, can react with aluminum and cause corrosion. Read the label before employing a cleanser. Rinse off the cleanser and allow the shutters to dry totally.
Achieving a Professional Finish
Use a dry brush to remove dust from your shutters, and set them flat with the faces up. Each shutter should rest on cinder blocks or other things that slightly elevate the shutters. This prevents ragged paint lines that can occur when the shutters are level on the ground. The trick to attaining a professional finish would be to apply multiple thin coats compared to one or two thick coats of paint.
It is best to start off with by spraying a light even coat of primer first and letting it dry. Follow with three or more very light coats of paint. It is always better to test spray a scrap of wood before applying it on the shutters. Simultaneous usage of aerosol and spray gun painting causes accumulation in spots and so stopping and starting is a matter of concern. To overcome this issue, use wide sweeping arm movements and begin spraying before the sprayer passes over the shutter. Do not release the aerosol gun trigger until the sprayer is past the shutter on the other side.
It is good to be aware of the regulations concerning the usage of aerosol paint. It is important to know about overspray that can result from aerosol painting or painting with a spray gun. Painting the shutters inside is not advisable unless the weather outside is not congenial. If you paint indoors, ventilation is crucial, but spray paint coming out of an open window can settle on the outside of a house or nearby structures.
Related Article: Covering Sunroom and Conservatory Windows with Plantation Shutters